Iowa Industrial Moderated Newsgroup For Surplus Equipment > Industrial Machine Repair
> Nuts and Bolts
> Needing Repair
> Microchip pic 12F629 8 pin soic .................. PI07
Microchip pic 12F629 8 pin soic .................. PI07
Microchip PIC 12F629-E/SN 8 Pin SOIC Flash Microcontroller - NOT RoHS
New - Non-RoHS Stock - Limited Quantities Available
Tennessee Residents must pay sales tax unless a resale certificate is on file.
* Flash Program Memory: 1024 words
* SRAM Data Memory: 64 bytes
* EEPROM Data Memory: 128 bytes
* Only 35 instructions to learn
* All single cycle instructions except branches
* DC - 20 MHz oscillator/clock input
* DC - 200 ns instruction cycle
* 8-level deep hardware stack
* Direct, Indirect, and Relative Addressing modes
Special Microcontroller Features:
* Internal and external oscillator options
* Precision Internal 4 MHz oscillator factory calibrated to ±1%
* External Oscillator support for crystals and resonators
* 5μs wake-up from SLEEP, 3.0V, typical
* Wide operating voltage range - 2.0V to 5.5V
* Extended temperature range
* Low power Power-on Reset (POR)
* Power-up Timer (PWRT) and Oscillator Start-up Timer (OST)
* Watchdog Timer (WDT) with independent oscillator for reliable operation
* Multiplexed MCLR/Input-pin
* Programmable code protection
* High Endurance FLASH/EEPROM Cell
* 100,000 write FLASH endurance
* 1,000,000 write EEPROM endurance
* FLASH/Data EEPROM Retention: > 40 years
* Standby Current: 1 nA @ 2.0V, typical
* Operating Current: 8.5μA @ 32 kHz, 2.0V, typical - 100μA @ 1 MHz, 2.0V, typical
* Watchdog Timer Current: 300 nA @ 2.0V, typical
* Timer1 oscillator current: 4μA @ 32 kHz, 2.0V, typical
* 6 I/O pins with individual direction control
* High current sink/source for direct LED drive
* Analog comparator module with: One analog comparator; Programmable on-chip comparator voltage reference (CVREF) module; Programmable input multiplexing from device inputs; Comparator output is externally accessible
* Timer0: 8-bit timer/counter with 8-bit programmable prescaler
* Enhanced Timer1: 16-bit timer/counter with prescaler; External Gate Input mode; Option to use OSC1 and OSC2 in LP mode as Timer1 oscillator, if INTOSC mode selected
* In-Circuit Serial ProgrammingTM (ICSPTM) via two pins
For your convenience a full copy of the specs are located here: http:// /pdfs/PI01.pdf
Click on image for EVEN larger photo
