Iowa Industrial Moderated Newsgroup For Surplus Equipment > Manufacturing Equipment
> Grinders
> Needing Repair
> Dayton 90,000 btu infrared lp gas heater
Dayton 90,000 btu infrared lp gas heater
Dayton 90,000 btu Infrared heater
High Intensity Unvented Infrared Heater, BtuH Input 90000, Radiant Surface 255 Square Inches, Typical Floor Coverage Diameter @ Mounting 27-32 @ 18-21 Feet, Height 14 3/8 Inches, Depth 22 1/2 Inches, Width 25 3/8 Inches, 25 Volts.
Clearance to Combustibles Ceiling (In.)
Clearance to Combustibles Back (In.)
Clearance to Combustibles Side (In.)
Clearance to Combustibles Below (In.)
* Gas-Fired Commercial Infrared Heaters
* 30-50% fuel savings over conventional systems.
* Provide instant, uniform heat directly to people and objects. Ceramic material heats to approximately 1780 DegreeF (high intensity) and generates large amounts of infrared radiation that is directed to the floor. Noncorrosive aluminum and stainless steel construction. Bright aluminum reflector. Electronic ignition,100% automatic gas shut-off control, and pressure regulator. Units are preassembled and ready to install. Installation information: Heated area requires 4 CFM of exhaust ventilation for every 1,000 BtuH of infrared heat (e.g. 120 CFM for a 30,000 BtuH heater, 240 CFM for a 60,000 BtuH heater, and 360 CFM for a 90,000 BtuH heater). Heaters must be mounted at a 20 Degree to 35 Degree angle from horizontal, preferably facing inward around the perimeter of heated area.
* Uses: For high ceiling applications and areas with large heat losses. Widely used for total or spot heating in factories, warehouses, service garages, foundries, etc.
* 1/2" NPT gas inlet; 120V 60 Hz power required
* Water-resistant circuit board on 120V models
