Iowa Industrial Moderated Newsgroup For Surplus Equipment > Manufacturing Equipment
> Vises
> Used and not new
> 1946 mini bronze working model centrifugal pump plans
1946 mini bronze working model centrifugal pump plans
A working model that will find several valuable uses
Excerpt: "The centrifugal pump, shown actual size in the photo, is a fine working model suitable for a table fountain or other liquid supply where a fine continuous stream is needed."
"Cast entirely of bronze, with stainless steel shaft, the pump can be mounted below the surface of the water, without danger of rust, where its performance will be at its best. Mounted in this manner it will start pumping instantly without priming."
"In having the three castings made for this little pump, patterns will be required. These can be made following the dimensions in the drawings."
1949 Original TWO-Page Magazine Article / How-to-Plan
