Iowa Industrial Moderated Newsgroup For Surplus Equipment > Food Service
> Food Warming
> Needing Repair
> New millermatic 180 mig welder-
New millermatic 180 mig welder-
All-in-one wire welding package welds 24 gauge-5/16 in(0.8 - 7.99mm) mild steel.
* Infinite voltage control with wire feed speed tracking provides broader operating range with finer control by automatically increasing or decreasing wire feed speed when voltage is adjusted.
* Durable cast aluminum feedhead incorporates dual groove quick-change drive roll and calibrated, spring-loaded tension arm designed to make setup easier and faster.
* Easy access to output studs provides convenient polarity changeover when switching from solid or flux cored wires.
* Built-in solid-state contactor circuit makes wire electrically "cold" until trigger is pulled. Makes unit safer, and is easier to position torch to work before starting weld.
* Thermal overload protection shuts down the unit and activates over temperature light if airflow is blocked or duty cycle is exceeded. Automatically resets when fault is corrected and unit cools.
* Flux Cored (FCAW) (gas and self-shielded)
* 130 A at 20 VDC, 30% Duty Cycle
* 10 ft (3 m), M-10 MIG gun and cable assembly with liner for .024 - .035 in (0.6 - 0.9 mm) wire.
* 10 ft (3 m) work cable and clamp.
* Argon and AR/CO2 mix regulator/flow gauge with hose.
* Sample spool of .024 in (0.6 mm) solid wire.
* Two contact tips for .024 in (0.6 mm) wire and two contact tips for .030 in (0.8 mm) wire.
* Dual groove drive roll for .024 in (0.6 mm) or .030/.035 in (0.8/0.9 mm) wire.
* Factory-installed contactor and gas solenoid valve.
* Information/settings chart.
