Iowa Industrial Moderated Newsgroup For Surplus Equipment > Painting Equipment
> Brushes
> Needing Repair
> Turned steel shaft
Turned steel shaft
This is a C12L14 Steel turned shaft that was used on ADC 630 Dryers. The total length is 26.16" long. One end starts with a .6247 diameter going back 1.75 inches to a shoulder where the diameter steps up to .9997 inch. The other end starts with a .4997 diameter going back 1.75 inches to a shoulder where the diameter steps up to .7497 inches, the first 1.13 inches of which is threaded 3/4-16 UNF-2A R.H thread, then goes back 2.56 inches (including the threaded area) to a shoulder where the diameter steps up to .9997 inch. Detailed PDF drawing available upon request.
